Introduction to DSown Evaluation Boards
ADCP9653E-125 Evaluation Board and Introduction
- The ADCP9653E-125 evaluation board from Sinoxtech adopts a configuration of an FPGA mainboard combined with an FMC daughterboard (high-speed ADC board).
- The FPGA mainboard is a development board based on the XILINX ZYNQ7000 platform (model: AX7350B).
- This ZYNQ7000 FPGA development platform uses the XILINX ZYNQ7000 SoC chip XC7Z035, which integrates dual-core ARM Cortex-A9 processors and FPGA programmable logic on a single chip through ARM+FPGA SoC technology.
- Both the PS (Processing System) and PL (Programmable Logic) sides of the ZYNQ are equipped with two 512MB high-speed DDR3 SDRAM chips each. Additionally, the PS side includes an 8GB eMMC storage chip and a 256Mb QSPI FLASH chip.
- The FPGA development platform provides a rich set of interfaces: 1 PCIe x4 slot, 2 optical fiber interfaces, 2 Gigabit Ethernet interfaces, 4 USB 2.0 HOST ports, 1 HDMI output, 1 UART serial port, 1 SD card interface, and an FMC expansion interface.
- The ADCP9653E-125 data acquisition daughterboard connects to the FPGA mainboard via a standard FMC interface. The acquisition board supports 4-channel data acquisition and includes a reserved external clock input interface, allowing users to select either an external or onboard clock source.
Core Specifications of the ADCP9653E-125 Chip：
-Supply Voltage: 1.8VLow Power
-Consumption: 164 mW per channel
-Signal-to-Noise Ratio (SNR):
76.5 dB S (at 70 MHz, 2.0 V p-p input range)
77.5 dB S (at 70 MHz, 2.6 V p-p input range)
-Spurious-Free Dynamic Range (SFDR): 90 dBc (up to Nyquist, 2.0 V p-p input range)
-Differential Nonlinearity (DNL): ±0.7 LSB
-Consumption: 164 mW per channel
-Signal-to-Noise Ratio (SNR):
76.5 dB S (at 70 MHz, 2.0 V p-p input range)
77.5 dB S (at 70 MHz, 2.6 V p-p input range)
-Spurious-Free Dynamic Range (SFDR): 90 dBc (up to Nyquist, 2.0 V p-p input range)
-Differential Nonlinearity (DNL): ±0.7 LSB
-Integral Nonlinearity (INL): ±3.5 LSB (2.0 V p-p input range)
-Serial LVDS interface, low-power, reduced-range option
-Full-power analog bandwidth: 650 MHz
-Input voltage range: 2 V p-p (supports up to 2.6 V p-p)
-Serial port control
-Serial LVDS interface, low-power, reduced-range option
-Full-power analog bandwidth: 650 MHz
-Input voltage range: 2 V p-p (supports up to 2.6 V p-p)
-Serial port control
